Share
Pin
Tweet
Send
Share
Send
You will need:
- Anvil.
- Hammer or hammer.
- Steel rod of non-hardened steel. Square or round does not matter.
All this is exactly in any workshop, and even more so in the blacksmith.
Making a fire in a blacksmith without matches
We put the end of the rod on the anvil. Hold the other end with your hand.
![](http://img.uaft2404.org/img/sdela-2019/kak-razvesti-ogon-bez-spichek-v-masterskoj-kuznice.jpg)
We strike the flattening end of the rod.
![](http://img.uaft2404.org/img/sdela-2019/kak-razvesti-ogon-bez-spichek-v-masterskoj-kuznice-2.jpg)
Next, turn the rod 90 degrees and strike again. Turn back and strike again. In general, we put it back and forth and hit it with a hammer.
![](http://img.uaft2404.org/img/sdela-2019/kak-razvesti-ogon-bez-spichek-v-masterskoj-kuznice-3.jpg)
Repeat the procedure. Metal from flattening will begin to generate heat.
![](http://img.uaft2404.org/img/sdela-2019/kak-razvesti-ogon-bez-spichek-v-masterskoj-kuznice-4.jpg)
Everything is repeated until the tip of the steel bar turns red.
![](http://img.uaft2404.org/img/sdela-2019/kak-razvesti-ogon-bez-spichek-v-masterskoj-kuznice-5.jpg)
Bright red.
![](http://img.uaft2404.org/img/sdela-2019/kak-razvesti-ogon-bez-spichek-v-masterskoj-kuznice-6.jpg)
Then we bring the hot part to dry paper and inflate it.
![](http://img.uaft2404.org/img/sdela-2019/kak-razvesti-ogon-bez-spichek-v-masterskoj-kuznice-7.jpg)
Immediately a fire breaks out.
![](http://img.uaft2404.org/img/sdela-2019/kak-razvesti-ogon-bez-spichek-v-masterskoj-kuznice-8.jpg)
That's all. An experienced blacksmith does this in 1-3 minutes. In the old days, this method was the main one, since matches were a curiosity, and not everyone had a flint.
Share
Pin
Tweet
Send
Share
Send