Flower made of paper "Harmony"

This flower looks very cute and romantic. It is very simple in its execution.
For work, we need:
- paper.
- cardboard.
- a pencil of pink color.
- glue gun.
- scissors.
Prepare a template for a flower. We take a square of cardboard measuring 10x10 cm. We use cardboard not too thick.
Fold the square in half, angles to each other. Just connect the two opposite corners.
Then fold again in half.
Fold again angle to corner to make such a small triangle.
We trim the corners, making the petal rounded.
Expand the petals, and we get such a pattern.
According to our template, we cut 4 pieces. The flower will consist of them. Lightly tint the edges of the petals with a pink pencil.
We collect all the blanks together and pierce the middle with a needle. Labeling, thus, where is the middle.
We begin to cut the workpieces to the middle of the hole marked with a needle.
We cut all 4 blanks in different ways. The first is just a notch. At the second we cut off 1 petal. Two petals are cut at the third workpiece. And finally, with the fourth cut 3.
We prepare the basis on which the flower will be attached. It will be a circle 3 cm in diameter. To make the flower stable, we will make the base from cardboard.
Getting to gluing blanks. Glue the petals on top of each other along the slices.
On all the workpieces below, cut the resulting angle.
We glue the largest workpiece onto the base with a glue gun. Let the glue dry.
Glue all subsequent blanks with petals staggered relative to each other.
We fix the last part, the middle, on the flower. Our flower is almost ready.
It remains only to tighten the edges of the flower petals. To do this, take a skewer and carefully twist each petal. All the flower is ready.
Good luck to all.